SASCA 2011 Points Event #10

[Shane]

SASCA 2010 Points Event #10 - Oct 16, 2011.

This event will be held at the Virgil T. Blossom Athletic Center, located in North-Central San Antonio, just north of the San Antonio International Airport.
The Pit area will be in the WEST parking lot, next to the school buses (yellow area on map).  
You will need to enter the facility via the driveway next to the school bus lot off of Jones-Maltsberger Rd (red marker on map).  
All other entrances will be blocked off.

View SASCA - Blossom Atheletic Center in a larger map

• Red Marker: Entrance, the ONLY Entrance
• Yellow Area: Pits and General Parking
• Green Area: Race Surface

The timeline/schedule of events will remain the same as usual for this event
Typical Event Schedule

REGISTER ON LINE! NO MEMBER DISCOUNTS FOR WALK UP REGISTRATION!
Online Registration: AXWare Online Event Registraiton
Walk-up Registration the day of the event is permitted though.

Morning Worker Assignments:
(names will be added by the event worker chief)


You can also view and link to our Google Calendar to keep up to date on event dates.
How to link to the SASCA Google Calendar
View the SASCA Google Caendar

[Li0nel1234]

Is there confirmation on this one yet or is it still tentative?

[John Patterson]

It's a go! We dont usually have last minute conflicts like last weekend. Keep in mind that our club meeting is this Wed if you are interested in attending.

[Li0nel1234]

Fiscal EOY... overtime at work. Otherwise I would go. I'll make the october meeting.

I can't wait for the next event... I've been dreaming about eating cones.

[Grasshopper123]

I signed up for gate control.  How much chance do I have to get that job,
or something like it?  Thanks.

[GreyLens]

Work Assignment Selection at Registration

We encourage everyone to register for each event via the axwaresystems.com registration site.  When you register you will be able to select your work assignment preference.  We appreciate you doing so because it makes it easier to organize the day and hopefully make it more likely you’ll do a job you enjoy.

Each work assignment will indicate the number of workers we need for each job for the day.  Simply look through the list of registrations and count the number of folks already signed up for the job you’d like.  If the position you want has not already been filled by the number needed then just select it.  You’ll likely get the job you requested but you could be asked to do something else instead.  The software will not block over selection of a particular job so please count the number of selections already made for the job you want before you select it.   If the job you want has been filled select a different one or you can wait till you get on site.

The number needed for each position is based on the assumption that we’ll only run two heats for the day, which is usually the case.  If we have over 90+ participants we’ll likely run three heats.  If so, we’ll assign positions for that third heat on site.  Again, this is a job preference request.  You may be asked to do something else if needed.  Thank you for your support.

List of Jobs on AXWARESYSTEMS for SASCA events:

1.    Trailer Tow Pick Up 0630   
2.    Gate Control 0645-0830   
3.    Event Master/Course Set Up Chief   
4.    Course Set Up Assist 1   
5.    Course Set Up Assist 2   
6.    Gate Control 0830 - 1000 approx   
7.    Tech Inspector Chief   
8.    Tech Inspector Assist   
9.     Set Up  0700-0930 (Need 4)   
10.  Gate Control for Heats (Need 2)   
11.  Timing Computer (Need 2)   
12.  Timing Radio (Need 2)   
13.  Timing Announcer (Need 2)   
14.  Timing Trainee (Need 2)   
15.  Starter (Need 2)   
16.  Grid Chief (Need 2)   
17.  Grid Assist (Need 2)   
18.  Course/Corner Control (Need 32)   
19.  Tear Down (Need 5)   
20.  Trailer Tow Return End of Day   

[Byrdgirl8201]

Im looking forward to this event. Not only will it be my second race, but its the day before my birthday. I cant think of a better way to celebrate.    I hope we get a good turn out for this event. By the way any one else in the group racing a dodge caliber? Would like some advice on how I can improve the handling and my time on the track. Thanks

[Li0nel1234]

Probably sway bars.  If you are sticking in stock you should check the rules before you mod your car. If that is no concern, check out the dodge forums as I'm sure others have modded your car.

good luck

[woody]

I wouldn't mind learning the timing trailer if y'all still are short on folks. 

[Grasshopper123]

I have a freind from the Tejas Miata club here in Austin, who would like to participate.  He has his
helmet.  But, he is not sure if he will be allowed as his Miata does not have a roll bar.   

Would he be able to run in Novice without a roll bar?  Please, someone, let me know, so that I
can tell him and give him the info on this event.

Thanks,
Alex

[Grasshopper123]

I got an answer from Chris that it is permitted to go without a rollbar.

[oscargarza88]

I'll be there!

Im willing to help out in the AM for whatever position needed.
Let me know

[John Patterson]

Oscar, you can pre-register on axwaresystems.com and sign up for whatever worker positions are available. Please check the entry list to see what positions have been spoken for besides corner worker stations.

[boxster_rs]

I'M IN FOR COURSE SET UP

[JeffCRZ]

Gotta work again, can't make it